INVERTER DAB ACTIVE DRIVER PLUS M/M 1.5/DUAL VOLT

Active Driver Plus presscontrols are inverters for the control and command of hydraulic pumps and find their natural application in constant pressure pumping systems: domestic, industrial and agricultural.

Thanks to the OLED display you have an extremely simple and intuitive graphical interface. Viewing or changing any parameters is extremely simple, this simplifies maintenance.

Installation is extremely simple thanks to assisted installation; the inverter asks the user for the parameters needed to be configured.

Active Drivers Plus allow a reduction in electricity consumption, thanks to inverter technology, while at the same time providing maximum comfort thanks to constant pressure.

They are extremely versatile because they do not require external sensors and check valve, in fact they have a pressure sensor, flow switch, and check valve inside.

The advantages of the Active Driver Plus are:

- comfort due to constant pressure.

- energy saving thanks to inverter technology.

- quieter operation

- compactness

- all built-in protections: dry run, amperometric, abnormal voltages, overtemperature and frost.

Line voltage: 115V and 230V single-phase. 400V three-phase

Electric pump voltage: 115V and 230V single-phase, 230V and 400V three-phase

Power supply frequency: 50 Hz - 60 Hz.

Installation: vertical and horizontal (only for M/M and M/T)

Maximum liquid temperature: 50°C.

Max. operating temperature: 50°C.

Max flow rate: 18m3/h.

Max pressure: 13 bar.

Pressure adjustment range: 1 to 13 bar.

Suction diameter (DNA): 1 1/4" male.

Delivery diameter (DNM): 1 1/2" female.

Degree of protection: IP55.

Group communication interface: YES one Active Driver Plus per pump.

Does not require a check valve.

Equipped with graphic display.